KINGSTON LAPTOP RAM HYPERX IMPACT 4GB (1x4GB) DDR3L-1600 (HX316LS9IB/4)

HyperX HX316LS9IB/4 is a 512M x 64-bit (4GB) DDR3L-1600 CL9 SDRAM (Synchronous DRAM) 1Rx8, low voltage, memory module, based on eight 512M x 8-bit DDR3 FBGA components. This module has been tested to run at DDR3L-1600 at a low latency timing of 9-9-9 at 1.35V or 1.5V. Additional timing parameters are shown in the PnP Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:

FEATURES

•  JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) Power Supply
•  VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)
•  800MHz fCK for 1600Mb/sec/pin
•  8 independent internal bank
•  Programmable CAS Latency: 11, 10, 9, 8, 7, 6
•  Programmable Additive Latency: 0, CL – 2, or CL – 1 clock
•  8-bit pre-fetch
•  Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
•  Bi-directional Differential Data Strobe
•  Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) • On Die Termination using ODT pin
•  Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
•  Asynchronous Reset
•  PCB : Height 1.180” (30.00mm), double sided component